Special Website Offer Price £1197.00

Twin Weber 40 DCOE 151 carburettor kit to fit a Ford 1600 x/flow engine in standard or mildly tuned form.

The inlet manifold is the 4242-40  3.1 inch long, drilled & tapped for brake servo & water take off unions as required.

Misab plates are used in place of the O ring plates. 

The LP2000 twin cable linkage with pedal block is top quality supplied by Webcon, & you will notice the cable entry is from the bulkhead side to make a neater installation! 

A fuel T piece union, upgraded fuel bolts & petrol pipe complete the setup which is supplied ready assembled for fitment to the engine. Inlet manifold gasket & water union included.

The total depth of this kit is 235mm.

The settings are as follows:

• Chokes 30mm,
• A.vents 4.5,
• Mains 115,
• Airs 200,
• Idles 45F9,
• Pumps 40,
• B/Bleed 50,
• Em.tubes F11,
• N/Valve 175.
• Rampipes are standard 39mm fitted length.

Reason to buy assembled

• No missing or incorrect parts
• No inlet manifold stud alignment fault
• On the bench balance setting
• Correct thackeray washer installation
• Inlet stud threads lock tightened in place

This kit is not assembled ready to go but is done after each sale so that all components are fresh & checked. This is done at the weekend when time is a little more forgiving. Shipping is then able to proceed on the following Monday (excluding bank holidays) with most deliveries for next day. Tracking details supplied.