Webcon supplied carburettor adaptor kit as shown in the image, to convert a single 2 stud carburettor to a 4 stud Weber or similar carburettor.

The 2 stud base can accept stud spacing up to 77mm & the 4 stud approx 48mm x 72mm.

The height from flange to flange is 42mm.

Weber Carb DCD/DGV Adaptor Kit 2 Stud to 4 Stud

Qty

One only! Weber 36 DCD 14 carburettor, part number 18910139. It is a progressive twin-choke &am..

£847.00 Ex Tax: £705.83

Weber 28/36 DCD & 36 DCD air filter top gasket...

£5.96 Ex Tax: £4.97

Warburettor to inlet manifold gasket 2mm thick suitable for the 28/36 DCD & 32/36 DGV or DFV typ..

£4.97 Ex Tax: £4.14

15mm spacer block & gaskets suitable for the Weber DGV, DGAV & DCD type carburettors. It is ..

£23.96 Ex Tax: £19.97

Redline inlet manifold & linkage bar suitable for the BMW 2002 to fit a Weber DCD,DGV,DGMS,DGES ..

£237.00 Ex Tax: £197.50

Weber shaft nut 3471501400 & lock tab 5552000200 to fit DGAV, DGV, DGAS, DMTL, ICH, DF..

£3.05 Ex Tax: £2.54

Idle jet holder to fit the DCD,DFM,DIR,DFV etc range of carburettors. Part number 52570.005...

£4.26 Ex Tax: £3.55

Fixing plate for the underside of the lid of a Weber 28/36 DCD to retain the starting device compone..

£4.64 Ex Tax: £3.87

Weber 32/36 DGV 5A, part number 2268000500S. It has the throttle linkage synchronised so both primar..

£288.00 Ex Tax: £240.00

Weber 32/36 DGV 5A, part number 2268000500S. It has the throttle linkage synchronised so both primar..

£288.00 Ex Tax: £240.00

Weber 32/36 DGV carburettor mounted on a Mangoletsi inlet manifold 45mm cleanable Air Filt..

£727.00 Ex Tax: £605.83

Write a review