ROVER V8 3.5/3.9 GENUINE NEW WEBER 45 DCOE 152G x4 CARBURETTOR/MANIFOLD/LINKAGE

Here are 4 genuine new Weber 45 DCOE 152G, 4 progression hole carburettors with a new 'John Eales' inlet manifold & thottle linkage, thermostat housing & throttle cable..

Not shown but will be included  a new inlet manifold gasket & extra fuel unions to combine the 4 carburettors with some petrol pipe to get you started. You may wish to fit aeroquip hosing to finish off this superb kit.

Unlike, most of the other kits this will not be ready assembled for ease of shipping & fitment to the engine.

The height of the kit from the top of the intake port to the highest point of the carburettors is 200mm. Overall width including the rampipes/air horns is 500mm

The gauze covers are supplied but an optional fitment

Please note fitting this kit means the oil filler cannot be used. It is recommended the later Rover SD1 v8 rocker covers are used so the oil filler will move to one end.

• Chokes 36mm
• Aux.vent 4.5
• Main jet 145
• Air jet 155
• Idle jet 55f8
• Em.tube f16
• Pump jet 45
• Needle valve 200
• Back bleed 40

Once fitment is completed a specialist rolling road setup will be required to obtain optimum performance.