FORD 1500 Pre Xflow Cortina-Anglia-Kitcar- Weber 40 DCOE x 2 Carbs

SPECIAL DISCOUNTED OFFER! £1297.00. PARTIALLY ASSEMBLED

Inlet Manifolds & Linkage made in UK. GENUINE 40 DCOE Weber Carburettors

This is a new twin genuine Weber 40 DCOE 151 carburettor kit to fit a Ford 1500 pre x/flow engine in standard or mildly tuned form as fitted to Ford Cortina Mk1, Ford Anglia or kitcar installation. The inlet manifolds  are genuine Mangoletsi 2 piece, drilled & tapped for brake servo if required, with LP2000 twin cable linkage. Misab  plates are supplied in place of the plastic O ring plates A fuel T piece union, petrol pipe & clips complete the setup which is supplied partially assembled for fitment to the engine.  Throttle linkage & levers can only be set up when on the car.

THE LAST IMAGE SHOWS A KIT FULLY ASSEMBLED ON A ONE PIECE MANIFOLD FOR GUIDANCE

The settings are:

Chokes 30mm, A.vents 4.5, Mains 115, Airs 200, Idles 45F9, Pumps 40, B/Bleed 50, Em.tubes F11, N/Valve 175. Rampipes are standard 39mm fitted length.

A range of air filters & shorter or longer rampipes also available in the shop.

Reason to buy partly assembled

• No missing or incorrect parts
• No inlet manifold stud alignment fault
• On the bench balance setting
• Correct thackeray washer installation
• Inlet stud threads lock tightened in place

This kit is not assembled ready to go but is done after each sale so that all components are fresh & checked. This is done at the weekend when time is a little more forgiving. Shipping is then able to proceed on the following Monday (excluding bank holidays) with most deliveries for next day. Tracking details supplied.